Creating a SAN with iSCSI - Part 5 - Setting up a Windows Initiator - Creating the Drive You will see the name of the target in the box: Click Log On to connect to the drive and make it active. You will see a dialog: For now, just leave automatic restore option unchecked. Click OK. Now the available target box has the target listed as connected: Click OK and go into the Computer Mangement administration tool. We can see our 3 gig drive: Let's look at the properties: Close the properties, right click on the left hand box marked Disk 2 Unknown, and write a signature to the drive so it is detected correctly. Next There are 6 parts to this article: Part 1 - Setting up the Target on GNU/Linux Part 2 - Setting up a Windows Initiator - Initial Install Part 3 - Setting up a Windows Initiator - Finish Install Part 4 - Setting up a Windows Initiator - iSCSI Setup Part 5 - Setting up a Windows Initiator - Creating the Drive Part 6 - Setting up a Windows Initiator - Finishing Up This article comes from NetAdminTools: http://www.netadmintools.com/ The URL for this story is: http://www.netadmintools.com/art375.html Copyright 1997-2008 NetAdminTools.com. Read our Terms of Use.