Debian on a USBCard -- Part 4 - Final Configuration
In this article we created a kernel for our USBCard system. Once we have the kernel in place we need to run lilo and adjust some other configuration files. To do this, just boot off of the Superrescue CD again and:
mount -t ext3 /dev/sda1 /mnt
chroot /mnt
|
Now, we can edit /etc/lilo.conf:
boot = /dev/sda
map = /boot/.map
image= /boot/vmlinuz
root=/dev/sda1
read-only
|
Your particular boot parameters, of course, may be different. We also need to edit /etc/fstab:
/dev/sda1 / ext3 noatime 1 1
/dev/sda2 none swap sw 0 0
proc /proc proc defaults 0 0
|
Run mkswap /dev/sda2 to set up your swap file. Also run lilo, now, and your system will boot using vmlinuz. One other thing we have to do is configure the network by editing /etc/network/interfaces:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
address 10.50.100.111
network 10.50.100.0
netmask 255.255.255.0
broadcast 10.50.100.255
gateway 10.50.100.82
|
|
|